Paperonium

Industrial chemistry · Nat Commun · 2026

Summary: its fastest run put 45.6% of the electricity into product. Its own results: 37%.

Fastest run: 345 micromoles an hour37%Its own results45.6%The summaryA different, slower runthe summary used this row35%404550
Fastest run: 345 micromoles an hour37%Its own resultsThe summary45.6%A different, slower runthe summary used this row35%404550

Share of the electricity that goes into making ethylene oxide

The paper says

A reactor uses electricity to turn ethylene into ethylene oxide, an industrial chemical. The paper’s summary says its fastest run made 345 micromoles (a count of molecules) an hour on each square centimetre of reacting surface, with 45.6% of the electricity going into the product.

Its own data show

That run used 50 milliamps of current (a flow of electrons) on each square centimetre. Each molecule takes 2 electrons, so that current can make at most 933 micromoles an hour; 345 is 37% of that, as its own results say. The 45.6% is from a slow run: about 10 milliamps, 100 micromoles an hour.

Electricity that misses the product feeds unwanted reactions, so a higher share means less waste. The paper says earlier attempts at this direct method typically stay under 40%. The summary’s 45.6% clears that line; the fastest run’s 37% does not. The paper’s comparison with earlier work also uses 45.6%.

“The summary” means the paper’s abstract: the short summary printed at its top, which is the part most readers see.

Read the paper →Full technical write-up →

Sustained Direct Electro-epoxidation of Ethylene via a Strain-Gradient CuO–Ag Interface · Nat Commun (2026) · doi:10.1038/s41467-026-72987-4